Nortel 5500 series, Руководство по установке

Страница: 50 / 70

50 Installing the Nortel Ethernet Routing Switch
It should be noted that configuring IP parameters in this manner does
not have the same amount of control as configuration using a Console
connection. Using this procedure will set the IP address to a pre-configured
default of 192.168.192.168.
To set IP parameters using the UI button, perform the following tasks:
Step Action
1 Press and hold the UI button for 3 seconds.
The unit will now be in configuration mode. The Status LED will now
change to a blinking green status.
2
Press the UI button 5 times.
The Base LED and the Up and Down LEDs will now be steady
amber to indicate that the button press was recognized.
3 Press the UI button and hold in for 3 seconds to confirm the
command.
The In-Use IP address will now be changed to 192.168.192.168.
The color and status of the Status LED will turn to steady green once
the command has been accepted. If the command is rejected, the
Status LED turns amber blinking.
4
Initial IP configuration using the UI button is now complete. To
continue with switch configuration access the switch through the
Command Line Interface, Web-based Management Interface, or
Java Device Manager.
—End—
Nortel Ethernet Routing Switch 5500 Series Stack Configuration
The Nortel Ethernet Routing Switch 5500 Series provides the capability for
fail-safe stackability. Up to eight 5500 Series devices can be connected in a
stack to provide uninterrupted connectivity for up to 384 ports. This stack is
managed as a single unit.
Stack connector
The stack connector is a component of the Nortel Ethernet Routing Switch
5500 Series back panel and consists of the Unit Select switch, Cascade
Down connector, and Cascade Up connector. The stack connector is
illustrated in the following diagram.
Nortel Ethernet Routing Switch 5500 Series
Installation
NN47200-300 2.00 Standard
5.0 7 July 2006
Copyright © 2005 - 2006, Nortel Networks Nortel Networks Confidential
.