Nortel 1002rp, Техническое обслуживание и диагностика

Страница: 208 / 218

Maintaining the Pentium III SBC card Standard 1.11
208 CallPilot
Replacing inline memory modules
The DIMM is located on the SBC. The gold-plated edge connectors on
DIMMs are designed to plug into matching edge-connector slots. The
design allows you to add or remove these modules repeatedly without
tools or without causing damage. Install a DIMM on the SBC only.
Capacity
The base CallPilot has one 512-Mbyte DIMM installed in Bank 1. No
other memory configurations are supported on this server.
Requirements
To add a DIMM to the card, you require the following:
„
an antistatic wrist strap
„
a DIMM with gold-plated edge connectors
To add an SDRAM DIMM to the SBC card
1 Remove the SBC card from the server and place it down on a flat
surface.
Note: To remove an old DIMM, perform steps 2 and 3. To add a
new DIMM, go to step 4.
.
CAUTION
Risk of electrical damage
Wear an antistatic ESD wrist strap when handling cards or
boards, or when working inside the server.