Nortel 1002rp, Техническое обслуживание и диагностика

Страница: 112 / 218

Replacing basic chassis components Standard 1.11
112 CallPilot
1 Unlock and open the double doors of the front bezel. See A in
Figure 14 on page 111.
2 Firmly grasp the front bezel by the hand-holds on either side of the
chassis, and pull the front bezel from the chassis. See B in
Figure 14 on page 111.
To remove the server cover
1 Remove the front bezel.
2 Power down the server and disconnect all power cords.
3 Loosen the three thumbscrews at the rear of the top cover.
4 Remove the server cover by pulling the cover toward the rear of the
chassis, and then lifting it up and off.
5 Clip the lead from your ESD wrist strap to an unpainted metal
section of the chassis.
To replace the front bezel after maintenance is
complete
.
DANGER
Risk of electric shock
High current inside the chassis can cause severe injury.
.
CAUTION
Risk of equipment damage
Take precautions to protect internal components. Electrostatic
discharge (ESD) can damage boards and make them unusable.
Wear an ESD wrist strap.