Nortel 1001t, Руководство по установке, Страница: 71 / 124

Installing hardware 2-17
Checking the hard drive(s)
Standard 1.0 Nortel Symposium Call Center Server May 1998
1001t Hardware Installation Guide
Checking hard
drives To check that each hard drive is securely installed, follow these
steps.
Caution: Risk of equipment damage. Handle hard drive(s)
carefully. Avoid even minor shocks to the hard drive to prevent
possible internal damage.
Customer-
supplied padlocks Three tabs are provided on the server chassis for customer-
supplied padlocks. One is located at the front hard drive bay
cover. There are two tabs at the rear of the chassis, one for each
side cover.
Step Action
1 Carefully check that each drive is securely inserted into the
bay by tugging gently on the black handle at the front of each
drive assembly.
2 If a drive assembly is loose, press down on the lever at the
top front of the assembly and pull the unit out of the bay.
3 Position the drive assembly in the guide rails.
4 Gently push the drive assembly into the bay until it docks with
the backplane connector and snaps into place.
5 Swing the bay door back into place. Rotate the thumbscrews
to secure the door.
6 Install a customer-supplied padlock if required.
7 Close the outer plastic door.