Nortek Security & Control | 1950 Camino Vida Roble, Suite 150 | Carlsbad, CA 92008-6517 | USA | 800-421-1587 | www.nortekcontrol.com
Copyright © 2015 Nortek Security & Control LLC.
2
10.
Insert the 2GIG Z-Wave module into the STM-5 connector on the PCB
and secure with the Phillips head screw.
Figure 8
GC3 Panel—Install the Z-Wave Module
11.
Replace the rear plate and secure it with two Phillips head screws.
12.
Connect the internal siren/speaker connector, the Piezo Sounder
connector, and the backup battery connector to their respective PCB
connectors.
13.
Install the backplate to the chassis and secure with the screw lock on the
bottom of the Control Panel.
14.
Install the Cellular Radio Module, if one was present.
15.
Install the hinged door.
(Optional) Lock/Unlock the Cellular Radio Module Door
The Cellular Radio Module fits into the bay on the side of the GC3 Panel and
features a built-in door lock under the faceplate. The Control Panel ships with the
door-lock screw in the UNLOCK position. To limit the possibility of someone
removing the door, installers have the option of moving the screw to the LOCK
position.
A
B
Figure 9
GC3 Cellular Radio Module Door Lock
To lock and unlock the Cellular Radio Module door:
1.
Use your fingertips or carefully insert a screwdriver at the edge of the
faceplate. Then gently pry the faceplate from the chassis.
Figure 10
GC3 Panel—Removeable Faceplate
2.
Remove the door-lock screw from the UNLOCK position on the right.
Figure 11
GC3 Panel—UNLOCK position
3.
Install the screw into the LOCK position on the left. This locks the hinged
door on the GC3 Control Panel.
Figure 12
GC3 Panel—LOCK position
4.
Snap the faceplate back on the GC3 Control Panel.
FCC Part 15: Class B Digital Device Statement
for the 2GIG-ZWM-500
If the module's label is not visible when installed, then an additional permanent
label referring to the enclosed module: "Contains Transmitter Module FCC ID:
WDQ-ZWM500" must be placed on the rear panel in a visible location.
FCC ID: WDQ-ZWM500
IC ID: 7794A-ZWM500
This device has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC Rules. Operation is subject to the following two
conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept interference received, including interference that
may cause undesired operation.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates and can radiate
2GIG® GC3 Security & Automation System
2GIG-ZWM-500 Z-Wave Module Installation Instructions
10008951A | Proprietary & Confidential
