Norstar Voice Mail 4.0, Руководство по установке и эксплуатации

Страница: 28 / 258

14
Setting up Norstar Voice Mail
Set Up and Operation Guide P0886600 Issue 1.0
Ending a session
To exit from a Norstar Voice Mail session you can do any of the following:
• hang up the receiver
• press an alternate line button
• press
®
• press
ƒ
.
The Voice Mail session ends in two to three seconds, except
when you are transfering a caller to a mailbox.
Interrupting a voice prompt
Each command shown on the telephone display is accompanied by a voice prompt.
On a Norstar two-line display telephone, the voice prompt plays after a five-second
delay. If you do not select an option, Norstar will disconnect the call. On a Norstar
single-line display telephone, the voice prompt plays immediately. When you do
not select an option within an additional four seconds, the voice prompt replays the
options before Norstar ends the session.
Norstar Voice Mail voice prompts provide the same options as the display button
options, and additional options not appearing on the display. When the voice
prompt plays the available options, it provides the dialpad buttons that invoke the
options.
When the voice prompt announces a display option with a corresponding dialpad
button, you can use the display button or the number on the dialpad. Either button
invokes the selected option.
A voice prompt can be stopped by pressing
£ .
A user cannot interrupt a prompt
that is informing the user of an error.
Press
•
to return the display to the previous display prompt.
There are no voice prompts for configuration options. All configuration commands
and options appear on the Norstar two-line display telephone.
Preparing to program Norstar Voice Mail
Once you have logged on using
ƒ·°‹ , you are ready to start
programing Norstar Voice Mail. The following diagram shows a high-level view of
the programing options available at this point.
For more detailed information on programing, refer to "Overview" on page 19, and
"Overview of Mailboxes" on page 49.