Norstar Voice Mail 4.0, Руководство по установке и эксплуатации

Страница: 220 / 258

206
Appendix A: Dialing Translation
Set Up and Operation Guide P0886600 Issue 1.0
Creating a DOS system disk
A DOS system disk is a floppy disk that has system files copied onto it. This type
of disk is required to automatically load the dialing translation table file onto the
Norstar Voice Mail system.
To create a DOS system disk:
1. Insert a blank 3.5" disk into the floppy disk drive of a DOS compatible
computer.
2. Ensure the DOS prompt is on the computer screen.
3. Type Format a: /s and follow the instructions shown on the screen.
Note: The default name for the floppy disk drive is a:. However, on computers
with two disk drives, the 3.5" drive may be named b:. If the drive is named
b:, replace a: with b: in the above command. If you are unsure of the name
of the 3.5" floppy disk drive, check the user manuals for your computer.
Creating an Autoexec.bat file
The Autoexec.bat file is a file that contains commands a computer automatically
executes when it starts up. In the following steps you are creating an Autoexec.bat
file that automatically loads the Dialing Translation Table file into the proper
location on the Norstar Voice Mail system.
To create the Autoexec.bat file:
1. Open the text editor program you used to create the Dialing Translation Table
file.
2. Create a new document.
Note: Type copy a:\dial.30 c:\st\dial.30 .
Note: This is the only text that should appear in the file.
3. Save the file as autoexec.bat .
Note: The file must be named exactly as shown above. Do not save this file
into the root directory (C:\) of your computer or you will destroy the
existing Autoexec.bat file.