NORMARC NM 7000 Series, Инструкция по установке и пусконаладке

Страница: 151 / 189

1250$5&
‹1DYLD$YLDWLRQ$6
,167580(17/$1',1*6<67(0
,167$//$7,21 &200,66,21,1*+$1'%22.
2 Tests and adjustments marker beacon
2.1
2.1.1 Preparations
Terminate the
RF OUT
terminal with a 50
Ω
load (antenna or dummy). The transmitters are fac-
tory adjusted to 2 watt output power. Let both transmitters run for ½ hour at this power to
achieve a stable working temperature before any fine tuning is carried out.
2.1.2 Configuration settings
Follow this procedure to set the configurations in the Marker Beacon according to desired sys-
tem configuration.
2.1.2.1 General Configuration
The static control strap on the Connection interface board sets hardware configuration,
remote access configuration and shutdown configuration. Figure 2-1 shows where the static
control strap is located on CI 1376
Figure 2-1 Location of Static Control Strap on CI 1376
DIG PORT A DIG PORT B DIG PORT C DIG PORT D
CI 1376
PB 1378
REMOTE
CONTROL
LINE
TEMP
OUTDOOR
TEMP
INDOOR
AC LEVEL ANA CHA1
ANA CHA2 ANA CHA3
RE
M
O
T
E
R
M
M
RS
2
3
2
RE
M
O
T
E
CO
NT
O
L
RS
2
3
2
CONFIGURATION
S1 S2 S3 S4 S5 S6 S7 S8
CONFIGURATION
S1 S2 S3 S4 S5 S6 S7 S8
HBK797/1