Nordson Sure Coat Series, Руководство пользователя по изделию

Страница: 33 / 66

Operation
4-5
2001 Nordson Corporation
All rights reserved
334 627B
Issued 3/01
Manual 31-46
NOTE: When you install the nozzle, there will be a gap between the
base of the nozzle and the front of the gun. Rotate the nozzle at least
90
from its previous position to prevent uneven wear and lopsided
patterns.
CAUTION: The nozzle nut and the inlet connector body at the
back of the gun hold the powder path components together. If
both are not tightened, gaps may appear between parts,
allowing for powder to build up and cause contamination during
color changes.
8. Assemble the gun. Tighten the inlet connector body at the back of
the gun to ensure that there are no gaps between the powder path
components.
Check the resistance of the multiplier and resistor assembly with a
megohm meter as described in the
Troubleshooting section. Replace the
multiplier or resistor assembly if the resistance readings are not within the
specified ratings.
3146026B
1
2
3
4
5
Fig. 4-2 Cleaning the Spray Gun
1. Spray gun
2. Powder feed tube
3. Electrode support
4. Nozzle
5. Nozzle nut
Weekly Maintenance