Nordson Spectrum II S2-900 C Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 43 / 262

Safety 2-3
•
Do not touch the dispensing head or other moving parts while the dispensing system is
operating.
•
To prevent burn injury, wear thermal gloves when working around heater tooling and fluid
heaters.
•
If your system is equipped with a laser height sensor, use extreme care to avoid looking
directly at the laser beam or its reflection off of mirror-like surfaces. See
2.10 Laser
Radiation for details.
•
Make sure the main power cable and main air supply hose are securely connected before
operating the dispensing system.
• If in a confined room, ensure adequate and uninterrupted air ventilation, and heating and
cooling meet environmental stress limits of personnel and the dispensing system.
• Where Volatile Organic Compound (VOC) emissions can exceed safe limits, facility
ventilation and filtration systems must be operational.
• Provide adequate space around the dispensing system to allow for movement of
maintenance and service personnel. Allow space for access doors and service panels to open
fully.
• Make sure all facility power sources are safely grounded.
•
Routinely inspect all air hoses and electrical cables for damage.
•
Make sure power cords and air supply hoses do not cross a walkway or aisle.
•
Before attempting to lift a load, take into consideration facility lifting and transport
precautions. See
2.6 Lifting and Transport Precautions
.
•
Maintain a clean and orderly work area.
2.4.2 Material Safety
•
Follow Safety Data Sheet (SDS) recommendations for the proper handling, cleanup, and
disposal of all materials and fluids and their containers (i.e., syringes, cups, reservoirs, etc.)
used with the dispensing system. See
2.5 Disposal
.
•
Follow SDS recommendations for the proper handling and disposal of all materials used for
cleaning dispensing equipment and spills.
• Make sure the dispensing system ventilation is ON during handling and cleanup of all
materials used with the dispensing system.
• Know the SDS recommendations for treatment of injury resulting from exposure to
hazardous materials.
• Always wear appropriate Personal Protective Equipment (PPE) as recommended by facility
safety practices and the material manufacturer’s SDS.
•
When working with multiple fluids, refer to the SDS to ensure the materials are compatible.
•
If possible, save or recycle unused materials. Refer to the SDS before saving or recycling
unused materials.
•
Do not dispense fluids with a flash point less than 93 °C.
•
DO NOT dispense toxic fluids (materials with a TLV of 200 ppm or lower).