background image

1

Nordson Corporation

OPERATOR’S CARD

P/N 229836A02

RA-20R Rotary Atomizer

Safety 

WARNING:

 

 

Allow only qualified personnel to

perform the following tasks.  Follow the safety

instructions in this document and all other

related documentation.

WARNING: 

 High-speed rotating equipment

can be hazardous.  Do not touch the cup, or

stand in front or alongside it while it is rotating.

Do not exceed the maximum speed rating.

WARNING: 

 Do not attempt to stop the cup

with your hands or any tool or other object.

Use braking air or let the turbine coast to a

stop.

WARNING: 

 Do not use defective cups.  A

defective cup can quickly damage the turbine

or fail and possibly injure the operator or other

nearby personnel.

WARNING: 

 People and equipment in the

vicinity of high-voltage electrostatic systems

can accumulate a dangerous static charge

unless they are grounded.

WARNING: 

 Shut off the turbine air, turn off

the electrostatic voltage, and relieve the fluid

pressure before you perform maintenance,

troubleshooting, or repair tasks.

To use this equipment safely,

S

always follow the instructions in this operator’s

card.

S

obtain and read the Material Safety Data Sheets

for all materials used.

Introduction 

This operator’s card contains operation, maintenance,

and troubleshooting procedures for the Nordson

RA-20R rotary atomizer.  Refer to the 

RA-20R Rotary

Atomizer

 manual for installation, repair, and parts

information.  Repair and parts information for the

turbine and valves used in the RA-20R rotary atomizer

are contained in separate manuals.

Содержание RA-20R









Отзывы: