10
11
8
Applicators PatternCoat
P/N 7135308_08
E
2014 Nordson Corporation
PatternCoat
5. Hang the piston rod in the adjusting device slide.
6. The lower edge of the piston should just reveal a groove (7). This
effectively seals the next groove. Otherwise the adjusting device must be
adjusted.
a. Set the application width on the adjusting ring such that the piston is
approximately in the center of the adjustment range. Ensure that the
adjusting ring has clicked into place.
b. Release the adjusting ring clamp (8).
c. Hold the adjusting ring in the locked in position and turn only the
spindle until the lower edge of the piston just reveals a groove (7). To
turn the spindle, e.g. insert a thin hexagon key into the bore (9) and
use it as a lever.
d. Tighten the adjusting wheel clamp.
8
7
9
7. Complete nozzle reassembly.
8. Attach the brackets (11) and insulation (10) to the desired side.
