Nordson Encore LT Automatic, Руководство пользователя по изделию

Страница: 42 / 71

Operation
4-8
Part 1604858-01
E 2013 Nordson Corporation
Interface Messages
Trigger LED flashing:
S
A trigger signal is received but the gun controller is disabled. Press the
Enable/Disable button to enable the controller.
S
A trigger signal is received but the conveyor is off or the controller is
locked out, or both. Start the conveyor and turn the keyswitch to READY.
Flow Rate display toggles between the setpoint and CO: Conveyor is off.
Total Air/Atomizing display toggles between the setpoint and LO:
Controller is locked out.
kV/ m A display flashes: Spray gun is shorted. Refer to Troubleshooting for
more information.
Shutdown
1. Purge the spray guns by performing a color change procedure as
described in your system manual.
2. Press the Enable/Disable buttons for more than one second to put the
controllers to sleep.
3. Turn off the system air supply and relieve the system air pressure.
4. If shutting for a long period of time, turn off the controller power.
5. Perform maintenance on the powder pumps and guns as described in
their manuals.
Maintenance
S
Perform the recommended maintenance procedures for the automatic
guns and pumps, as described in their manuals.
S
Periodically check the air filter in the base of the multi-gun controller.
Drain the filter bowl and change the element as needed. Refer to Parts
for the replacement filter element part number. Do the same for filters
used with single and dual gun controllers.
S
Periodically check all system connections. Make sure all equipment in
the spray area is securely connected to a true earth ground. Vacuum
dust and powder from equipment.
Recommended Cleaning Procedure for Powder Contact Parts
Nordson Corporation recommends using an ultrasonic cleaning machine
and Oakite r BetaSolv emulsion cleaner to clean gun and pump powder
contact parts.