Instruction Sheet
Part 1100985A
E
2010 Nordson Corporation
P/N 1100985A
Encore
r
Display Module Kit 1100986
Description
Use this instruction sheet to replace the original Encore Manual Gun display
module with the new display module kit 1100986. The additional ground
cable included with the display module provides additional protection for the
electronics inside the display module.
Follow these instructions carefully to ensure that the display module is
correctly installed and grounded.
Preparation
1. Turn off the gun.
2. Remove the nozzle nut, nozzle, and electrode assembly from the gun.
3. Disconnect the powder feed hose adapter, black purge air tubing, and
clear electrode air wash tubing from the gun handle.
4. Disconnect the gun cable from the controller interface module.
5. Move the gun to a clean workbench.
Display Module Removal
1. See Figure 1. Unscrew the top (M3 x 30) screw (11) holding the hook
(10) and display module (9) onto the gun body.
2. Slide the hook off the display module (9).
3. Unscrew the bottom (M3 x 20) screw (12).
4. Carefully pull the display module away from the gun.
5. Disconnect the gun cable/display module connectors (J3).
6. Carefully remove the adhesive support pad and the trigger switch
header from the display module.
7. If the adhesive support pad remains stuck to the trigger switch header,
carefully peel the pad off.
