Nordson 1006453A, Руководство пользователя по изделию, Страница: 12 / 24

Ejector Gun Controller 8
E
2001 Nordson Corporation
All rights reserved
1006453A
Issued 6/01
Manual 25-23
WARNING: Allow only qualified personnel to perform the
following tasks. Follow the safety instructions in this document
and all other related documentation.
Follow these procedures when installing your Ejector gun controller and
preparing it for operation:
NOTE: When mounting the controller cabinet, be sure to allow clearance
for the door to open and for all cable connections supplied to the cabinet.
See Figure 1.
1. To connect main power to the Ejector gun controller, connect the
cable from the robot to the controller main power connector (1).
2. Connect the cable from the gun communication connector (6) to the
junction box near the guns.
3. Make all system electrical connections according to the system
schematics provided in your system documentation. If you have any
questions, contact your Nordson representative.
WARNING: Allow only qualified personnel to perform the
following tasks. Follow the safety instructions in this document
and all other related documentation.
The following paragraphs detail the operation of the Ejector gun
controller. Read this entire section before performing any procedures.
The following provides information on how to use the controller keypad.
See Figure 2 , which shows what each button on the keypad represents.
Refer to Table 1 for an explanation of the keypad functions.
3. Installation
4. Operation
Keypad