Operation
25
4. Select the number of fiducials and click on
OK
.
If one or more fiducials are selected, you will be prompted to teach fiducial location.
Refer to the
Fluidmove User Guide
for instructions.
The Programming Window (Workpiece Pattern) opens. See the
Fluidmove User Guide
for information on creating additional patterns.
5. Add a height sense command.
a. In the Programming Window, select
Program > Process Commands > Find
Substrate Height
.
b. Follow the prompts.
6. Select the tilt direction.
a. In the Programming Window, select
Program > Process Commands > Tilt
.
b. Select the tilt direction and click on
OK
.
Available tilt directions depend on software configuration. See
Figure 4-16 Set Tilt Instruction
7. Add dispensing instructions. See the
Fluidmove User Guide
for detailed information.
NOTE
All dispensing instructions after a Set Tilt Instruction will be performed at that tilt angle
until the next tilt instruction.
4.6
Running a Program
When the program is run, the system will verify that offsets have been run for all dot and line types in the
program.
To run production:
1. Click the
Run
button.
The
Run Production
button appears in the Production Window, along with the manual
run commands (Figure 4-17).
NOTE
Clicking the
Run Production
button opens the Run Window. It does not start the
production run. To start the production run, you must click on
Go
in the Run Window.
Содержание Spectrum S-9 Series
Страница 1: ...Spectrum Series Single Axis Automatic Tilt Mechanism Owner s Manual...
Страница 6: ......
Страница 10: ......
Страница 34: ......