Nordost VALHALLA 2, Инструкция по эксплуатации, Страница: 6 / 12

TONEARM CABLE +
1. CONNECTING
TYR 2 TYR 2
PHONO-STAGE TURNTABLE
Connect the DIN / RCA / XLR
connectors to the outputs on
your turntable and inputs on your
phono-stage. For RCA and XLR
configurations, the red wire denotes
right channel, and the black wire
denotes left channel.
Please note that Nordost tonearm
cables are directional. To correctly
orient your cable, make sure that
any arrows found on the breakout
barrels are pointing towards your
phono-stage.
If you are experiencing any noise
(hum) while listening to your
turntable set-up, you are most
likely suffering from a ground loop.
In order to eliminate this problem,
you must address the grounding
between your turntable and
phono-stage. Most turntables and
phono-stages are equipped with
ground screws on their chassis.
Connect the Bond Ground Wire
(the wire terminated with spade
connectors that is permanently
attached to the tonearm cable) to
2. GROUNDING
the ground screws on both your
turntable and your phono-stage.
This connection will bond the two
chassis together, creating a secure, low noise connection between the
two components.
TYR 2
LEFT CHANNEL
RIGHT CHANNEL
ARROWS POINT IN DIRECTION OF SIGNAL