Nordmann Engineering Omega 12, Руководство по эксплуатации

Страница: 51 / 104

51
6.3 Settings in the "Engineering" menu
Accessing the menu "Engineering"
• Press the <Menu> button on the top right corner of the display. Then, enter the password "0000" (if
main menu is configured with password protection). The main menu appears.
Note: The password for the user menu can be modified in the "Engineering > Administration >
Password" submenu.
• Select menu item "Engineering" in the main menu.
• Enter the password ("1055") in the password entry window that appears and confirm. Then, the
"Engineering" menu appears.
Note : The content of the "Engineering" menu depends on the selected SPA application. The following
description of the settings lists all available parameters of the "Engineering" menu.
Setting parameters Menu "Engineering"
SPA Control Board
Note : This menu appears only on the Condair Delta SPA Control Box and on the Nordmann Omega with SPA Control.
System Mode Determining in which system mode the SPA Control Board should run.
– Steam Generator: Setting for the operation of the Nordmann Omega with Omega Control
as a pure steam generator for steam shower application. The steam production is controlled
by a demand signal from an external controller.
CAUTION! With this setting bathing time is not monitored. Make sure that the external
control monitors the maximum allowed bathing time!
– Wellness: Setting for single cabin application. The control takes place in accordance with
the application via the device-specific control of the Condair Delta SPA Control Box or the
Nordmann Omega.
– Wellness Dual: Setting for dual cabin application for small cabins. The control of the two
cabins takes place in accordance with the application via the device-specific controls of
the Condair Delta SPA Control Box or the Nordmann Omega with SPA Control.
Cabin Kind Determining of the SPA application
– Steam shower
Note : Steam shower application for the Nordmann Omega with Omega Control. The steam
production is either temperature controlled or with constant steam operation.
The following SPA applications appear only on the Condair Delta SPA Control Box and on the
Nordmann Omega with SPA Control.
– Steam Bath
– Caldarium
– Rasul
– Bio Sauna
– Fin sauna
Generator Kind Determining of the type of steam generation used for steam shower, steam Bath, Rasul or Bio
sauna application
– None: There is no steam generator used.
– Internal Omega: The steam is produced by a Nordmann Omega with SPA Control.
– Internal Reservoir: The steam is produced by a water reservoir integrated in the sauna
heater of the Bio Sauna.
– External Omega: The steam is produced by a Nordmann Omega with Omega Control.
– External Analog: The steam is produced by an external steam generator, which is controlled
by a demand signal.
Signaling Activation ("On") or deactivation ("Off") of the beeper for fault/warning signalisation.
Stage Control Setting the Eco mode for steam/heat production.
– Eco Mode: Activation ("On") or deactivation ("Off") of the Eco mode. Eco operation ensures
that not more than 9 kW (3 kW per phase) steam output (heat output) or sauna output is
consumed. This is important for Bio sauna applications, which have an additional water
reservoir connected to the 9 kW sauna power. If the Eco mode is activated, the power of
the sauna heater will be reduced to 6 kW as soon as the water reservoir is switched on.