background image

®

R AT BLOCKER TX11

- INSTALLATION MANUAL

Applies to rat blocker TX11 with gate moun-

ted with thumbscrew.

N.B.

 

Before mounting, always check that the thumbscrew is tightened 

Содержание RAT BLOCKER TX11

Страница 1: ... R AT BLOCKER TX11 INSTALLATION MANUAL Applies to rat blocker TX11 with gate moun ted with thumbscrew N B Before mounting always check that the thumbscrew is tightened ...

Страница 2: ...rom opening The pictures below show the correct position of the gates in relation to the drainage direction REVERSAL OF THE GATE If the locking direction needs to be chan ged loosen the thumbscrew approx two turns after which the gate is turned 180 degrees Make sure the two pins are properly seated in the guide slot Then tighten the thumbscrew again and the rat blocker is ready for fitting The arr...

Страница 3: ...ocker s stopper is in contact with the well s side Then turn the mounting pipe clockwise until desired tension is achieved Removed the alignment tube and the installation is ready for a test flush For the test flush use 6 7 pieces of toilet paper and 2 3 toilet flushes from the toilet you should be able to visually confirm that the paper and water is able to pass the rat blocker unhindered After i...

Страница 4: ...d piece on the rat block ers from Nordisk Innovation is made of acid resistant stainless steel which has subsequently been coated with a layer of hard chromium plating In addition we recommend that during service and maintenance of the rat blocker the threaded piece is lubricated with mounting paste We recommend the following products for lubrication CRC Lubricant Ceramic Paste UNICAN ASW 1400 UNI...

Отзывы: