27
PROBLEM: The walking belt is off-center or slips when walked on
a.
If the walking belt has shifted to the right:
Remove the key and unplug the power cord.
Using a 7/32" hex key, turn the roller adjustment
bolts in the directions shown, 1/4 of a turn each.
Be careful not to overtighten the walking belt.
Then, plug in the power cord, insert the key,
and use the incline trainer for a few minutes.
Repeat until the walking belt is centered.
b.
If the walking belt has shifted to the left:
Remove the key and unplug the power cord.
Using a 7/32" hex key, turn the roller adjustment
bolts in the directions shown, 1/4 of a turn each.
Be careful not to overtighten the walking belt.
Then, plug in the power cord, insert the key,
and use the incline trainer for a few minutes.
Repeat until the walking belt is centered.
c.
If the walking belt slips when walked on:
Remove the key and unplug the power cord.
Using a 7/32" hex key, turn both roller adjust-
ment bolts clockwise 1/4 of a turn. When the
walking belt is properly tightened, you should be
able to lift each side of the walking belt 2.5 to 5
cm (1 to 2 in.) off the walking platform. The cen-
ter of the walking belt should just touch the
walking platform. Make sure to keep the walking
belt centered. Then, plug in the power cord, in-
sert the key, and run the incline trainer for a few
minutes. Repeat until the walking belt is prop-
erly tightened. Note: As you tighten the roller
adjustment bolts, the front roller will move.
If the front roller stops moving, do not further
tighten the roller adjustment bolts; please see the back cover of this manual.
a
Right
b
Left
c
