5
M10 x 55mm Screw (16)
M10 Locknut
(24)
M6 Washer (23)
M6 x 60mm Screw (19)
M10 x 256mm Bolt (17)
M10 x 45mm Bolt (18)
M6 x 25mm
Screw (20)
M10 Washer (22)
M5 x 15mm
Screw (21)
PART IDENTIFICATION CHART
See the drawings below to identify small parts used in assembly. The number in parentheses by each drawing is
the key number of the part, from the PART LIST near the end of this manual.
Note: If a part is not in the hard-
ware kit, check to see if it has been preassembled.
ASSEMBLY
To make assembly easier, carefully read the
following information and instructions:
• Assembly requires two persons.
• Because of its weight and size, the weight bench
should be assembled in the location where it will
be used. Make sure that there is enough clear-
ance to walk around the weight bench as you
assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• For help identifying small parts, use the PART
IDENTIFICATION CHART above.
• The following tools (not included) may be required
for assembly:
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Assembly may be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
All manuals and user guides at all-guides.com