6
3
14
1
Grease
48
48
76
76
99
99 Tubes
3. Slide a Ramp Cover (48) onto an M6 x 16mm Patch
Screw (76) as shown. Tighten the Patch Screw into
one end of the Pivot Axle (14), which is the longer of
the two axles. Apply a small amount of the included
grease to the Pivot Axle.
Have a second person hold the two Ramp Spacers
(99) against the sides of the Frame (1) so that they
cover the indicated tubes on the Frame. Align the
round tubes on the Ramp (3) with the Ramp Spacers.
Make sure that the Ramp is turned as shown in
drawing 4 below. Insert the Pivot Axle (14) into the
Ramp, the Ramp Spacers, and the Frame. If neces-
sary, tap the Pivot Axle with a rubber mallet to insert it.
Slide a Ramp Cover (48) onto an M6 x 16mm Patch
Screw (76) as shown. Tighten the Patch Screw into the
open end of the Pivot Axle (14).
4
4. Slide an M6 Washer (64) onto an M6 x 16mm Patch
Screw (76). Tighten the Patch Screw into one end of
the Incline Axle (13). Apply a small amount of grease
to the Incline Axle.
Raise the Ramp (3). Insert the Incline Axle (13) into
the welded tube under one side of the Ramp, through
the motor screw, and then into the welded tube under
the other side of the Ramp. As you insert the Incline
Axle through the motor screw, make sure that the
motor screw does not turn.
Slide an M6 Washer (64) onto an M6 x 16mm Patch
Screw (76). Tighten the Patch Screw into the open
end of the Incline Axle (13).
13
Grease
Motor
Screw
64
76
3
2. While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (6) to the Frame with four
M8 x 44mm Button Screws (84) and a Support Plate
(104) as shown.
6
1
104
84
84
2
Tubes
64
76
3