7
7. While another person holds the Console (9) near
the Handlebar (7), connect the wire harness on the
Console to the Upper Wire Harness (51). Next, con-
nect the pulse wire on the Console to the Pulse Grip
Wire (10). Note: The remaining wire on the Console
is used during the manufacturing process; disregard
this wire.
Insert the excess wiring downward into the
Handlebar Post (6). Attach the Console (9) to the
Handlebar (7) with four M4 x 16mm Screws (54).
Be careful to avoid pinching the wires.
7
9
7
6
7
10
54
46
6
Pulse
Wire
6. Attach the Handlebar (7) to the Handlebar Post (6)
with four M6 x 30mm Button Screws (46). Be care-
ful to avoid pinching the wires in the Handlebar
and the Handlebar Post.
6
51
Wire Harness
5. The Console (9) requires four 1.5V “D” batteries
(not included); alkaline batteries are recommended.
IMPORTANT: If the exercise cycle has been
exposed to cold temperatures, allow it to warm
to room temperature before inserting batteries
into the Console. If you do not do this, the con-
sole displays or other electronic components
may become damaged. Press the tabs on the bat-
tery covers and remove the battery covers. Next,
insert four batteries into the Console; make sure
that the batteries are oriented as shown by the
diagrams inside the Console. Then, reattach the
battery covers.
Note: The Console (9) can be operated with an
optional power supply instead of batteries. To pur-
chase a power supply, call the toll-free tele-
phone number on the front cover of this manual.
Plug one end of the power supply into the jack at
the front of the exercise cycle. Plug the other end of
the power supply into an appropriate outlet that is
properly installed in accordance with all local codes
and ordinances.
5
Battery
Covers
Batteries
Batteries
9
