PROGRAMMING OPTIONS
Your installer can program the following:
x
Engine run time: 4, 15 or 25 minutes.
x
Number of retries: 2, 3 or 4 times.
x
Maximum crank time: 6, 8 or 12 seconds.
x
Child proof feature.
x
Trunk release or Garage door control.
x
Idle mode feature.
x
Secure Lock.
DIAGNOSING PROBLEMS
Poor transmitting range
There are many factors that affect operating range. Some of these are:
x
Battery condition
x
Operating environment (Downtown RF noise)
x
Metal: any type of metal will affect operating range. Range in a
crowded parking lot will be significantly lower than open space.
x
Transmitter orientation: always hold the transmitter high;
approximately shoulder height. Holding the transmitter under the chin
will improve performance. Try it!
Engine does not start
If the engine does not start, check the following:
x
Is the transmitter LED working? If not, check the battery .
x
Are you pressing the transmitter long enough? Press the transmitter
until the Parking lights activate.
x
Check the Valet switch. When the power is turned ON, the Parking
lights will flash twice to confirm power up.
VALET MODE
Nordic Start is equipped with a Valet switch (ON / OFF) make sure that all
users of the vehicle know the location of the switch.
* To put the unit into Valet mode, simply turn the under dash switch to
OFF (system should now be in Valet)
BASIC REMOTE OPERATIONS
The remote control unit has three buttons. Button 1 (LOCK) is used for
remote keyless entry. Button 2 (START) will start the vehicle. Button 3
(TRUNK) is for the convenience of remote trunk release.
To start the car by remote, you must ensure that the Hood is closed and that
the Valet switch is in the ON position. Press START, for about 1 second
(or 4
to 5 if the Child Proof feature was enabled by your installer).
Once the Button
has been pressed the Parking lights will come ON to inform you that the unit
has received your signal, and has begun the start process. The car should be
running after about 5 sec. The vehicles Parking lights will stay on the entire
pre-programmed run cycle.
NOTE:
Do not continue to press the remote once the Parking lights activate.
Pressing the remote continuously for 4 seconds will activate “Cold Weather
Mode” and will Not start the engine.
If the vehicle doesn’t start, the Nordic Start will shut OFF, wait a few seconds,
and then re-try to start the engine again. The Nordic Start will try to start the
engine a total of 2, 3 or 4 times (programmable) before giving up.
With the vehicle running under remote control, enter the vehicle. Insert
the key in the Ignition and turn the key to the “ON” position.
Do not turn
the key to the “START” position with the engine running, this will cause
the starter motor to reengage.
NOTE:
Do not forget to leave the heather or air conditioner turned ON before
leaving your vehicle. So that your vehicle can be “PRE-WARMED” or
“PRE-COOLED” by remote control.
REMOTE DOOR LOCKS
If your system was installed with remote door locks, you will have the
convenience of remote keyless entry. To UNLOCK you doors, press and hold
Button 1 for about 1 sec. Once the doors have unlocked the Parking lights
will flash twice to confirm that the doors are unlocked
. (Also disarming your
starter kill.)
To LOCK your doors, press Button 1 on your remote. When the
doors have locked, the Parking lights will flash once.
(Arming the starter
kill.)
USER-GUIDE
NS-1003/433
Rev: 2.01 La – 08/09/01 Manufactured in Canada by NORDICSTART
4
