Nordic Semiconductor PCA63511, Руководство пользователя

Страница: 13 / 31

Doc. ID 4425_027 v1.0 Page 13
Chapter 4
Installing the Power Profiler Kit
software package
This section describes the installation procedure for the Power Profiler Kit (PPK) software package. Python
2.7.12 environment, SEGGER J-Link and the nRF5x Command Line Tools for Microsoft Windows are required
before the PPK software package is installed.
To install the PPK software package, complete the following steps:
1. Install the prerequisite tools:
a) Download and install the Python 2.7.12 environment from
python.org .
Important:
• Select the 32-bit Microsoft Windows x86 Installer (MSI).
• Make sure to select the option to add Python to path during the installation.
b) Download and install the SEGGER J-Link driver from the
Downloads
section (tab) of the nRF52 DK
package in nRF52 Development Kit .
Alternatively, the SEGGER J-Link driver can be downloaded from SEGGER J-Link Software .
c) Download and install the nRF5x Command Line Tools for Microsoft Windows from nRF5x Tools
Windows32 .
2. Download the PPK software package from http://www.nordicsemi.com/Products/Power-Profiler-Kit .
The file format is
PPK_SW_vX_X_X_X_X.zip
, where X sets the revision history.
Important: The latest version is always available from the link provided above.
3. Unzip the software package to a directory of your choice on your computer.
4.
Navigate to and run the file
python_packages.bat
.
This will install the following:
• pyside
• pyqtgraph
• numpy
• pynrfjprog
• future
Important:
The software will not run before a PPK board is connected to the computer as described in
the following chapter.