Nordcap 406600891, Руководство по обслуживанию

Страница: 36 / 76

36
LIBERO LINE HOB INDUCTION
The temperature sensor is located at the center of the coil; if the temperature is spiking over set point of max
temperature (260° ) the safety sensor will slowly cut down the power of the generator, if the temperature of the
surface does not go down and it reaches 280C° the sensor will input to shut down the Generator.
There is no manual resetting of the temperature sensor, this because it is electronically controlled; once that
the appliance has cooled down (the appliance will keep in function the ventilation system in case of safety
temp. activation) the appliance will turn back on and restart functioning.
In case of overheating an alarm will be displayed on the U.I. § ALARM CODE LIST
INDUCTION POTS, PRECAUTIONS
All pots must be designed to be used on induction appliances; generally, all are branded with the indicated
logo on the bottom.
Use pots with bottom in iron, iron plate, enameled iron, cast iron, special multilayer metal.
Do not use pots in layered metal with aluminum body and open edge.
The heating system will not work with unsuitable materials; these are: nickel chromium, S/steel, aluminum,
copper, brass, glass, porcelain. Pots with diameter less than approx. 12cm are not recognized by the system
or could create tech issues with the generators (overheating or other alarm messages).
Do not use pots with a MAX diameter of 28cm or higher, this in order to obtain the maximum heating efficiency.
To avoid compromising inductor functionality, never use pots with bottoms that are not perfectly flat: the tem-
perature may not be measured correctly, damaging the appliance.
Do not use empty pots or pans on the appliance as they can quickly (in a few seconds) reach very high tem-
peratures.
General indications on how to place / position the pot & pans onto the cooking zones.
NOTE !
the temperature probe and coil are part of the generator assembly and not available as single spare
parts.