/
555
-
need to purchase the cables from your vendor or a local
computer store.
To connect your printer to a single PC, you need a parallel cable
with a 25-pin male connector and a 36-pin male connector.
$ "
Your printer supports both Centronics parallel and IEEE 1284 bidirec-
tional parallel communications. The type of parallel cable you use
depends on the type of parallel communication your computer sup-
ports (check your computer user’s manual if you’re unsure).
If your computer supports IEEE 1284 bidirectional parallel com-
munication, you need an IEEE 1284 bidirectional parallel cable
(IEEE 1284 is indicated on the cable). This cable must be 6.5 feet
(2 meters) or less in length.
If your computer supports only Centronics parallel unidirectional
communication, you may use either a Centronics parallel cable
(unmarked on cable) or an IEEE 1284 bidirectional parallel cable
(IEEE 1284 is indicated on the cable). QMS recommends the
IEEE 1284 cable. The IEEE 1284 cable must be 6.5 feet (2
meters) or less in length while the Centronics cable may be
longer.
!
1
Turn off both the printer and the PC.
2
Connect the PC and the printer using a parallel cable.
a
Connect the 25-pin end of the cable to the PC’s parallel port,
and then tighten the screws.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
