#
1
Press the metal plate until
it latches.
2
Squeeze in the retainers
to move the media guide
clips all the way toward the
outer edges.
3
Align the four corners of the
media stack, and insert it
under the fluke at the front
right side, with the print side
facing down.
A fill-limit mark is on the inside
of the cassette.
»
Note:
Make sure the top sheet is under the fluke. Do not load
more sheets than the maximum specified.
4
Squeeze the media guide
clips to move them to the
size of the media.
Make sure the media corners
are not bent upward by the
guides.
»
Note:
If the guide clip is pressed too tightly against the media, it
may cause a jam.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
