nord modular G2, Руководство пользователя

Страница: 171 / 233

NORD MODULAR G2 V1.1 11. Module reference: Switch group
Page 167
M M M M
U
U U
UX
X X
X
8-1 8-1 8-1 8-1
The 8-1Multiplexer has eight inputs and
one output. The channels are enabled by
sending a control signal on the Ctrl in-
put. See also
"Common Switch parameters” .
M
M M
M
U U U UX X X X
1-8
1-8 1-8
1-8
The 1-8Multiplexer has one input and
eight outputs. The channels are enabled
by sending a control signal on the Ctrl
input. See also
"Common Switch parameters”
M M M M
U
U U
UX
X X
X
8-1X 8-1X 8-1X 8-1X
The 8-1 X-Fade Multiplexer has eight
inputs and one output. The channels are
enabled by sending a control signal on
the Ctrl input. You can also define the
amount of crossfade between adjacent
channels with the X-Fade knob. The crossfade function is displayed in the graph. See also
"Common
Switch parameters” .
S S S S
A
A A
AM
M M
MP
P P
PL
L L
LE
E E
E
&H &H &H &H
O
O O
OL
L L
LD
D D
D
This module takes samples of the values
of an incoming signal. The sampling of
the input signal occurs every time a sig-
nal shifting from 0 units or below to anything above 0 units appears at the leftmost input. Inbetween
these “trig” signals, the module transmits the value of the latest sample to the output. See also
"Common
Switch parameters” .
To create the traditional Sample & Hold or random LFO synthesizer effect, connect the output of a white
noise generator module to the input of the Sample & Hold module and trig the Sample & Hold module
with an LFO. Connect the output of the Sample & Hold module to a Pitch modulation input of an os-
cillator according to the figure below:
T
T T
T
R R R RA A A AC C C CK K K K
&H
&H &H
&H
O O O OL L L LD D D D
This module is similar to the Sam-
ple&Hold module described above, but
with one difference. Instead of just tak-
ing a single sample at a time, the Track&Hold module acts like a combination of a switch and a Sam-