Installation Instructions
***URGENT: READ PRIOR TO ATTEMPTING INSTALLATION***
SPECIALTY LIGHTING
-
RGB LED TAPE LIGHT
ALwAYS TuRN off mAIN PowER BEfoRE INSTALLATIoN
Item#
Description
Rating
NUTP3 Series
24V RGB LED Tape Light
24V / 2.5W/ft.
NUPT6 Series
12V RGB LED Tape Light
12V / 2.5W/ft.
INSTALLATION SHOULD BE CARRIED
OUT BY YOUR LOCAL ELECTRICIAN.
Installation Instructions:
1. Decide where you want to place the LED tape light.
2. The tape light has a 3M™ self-adhesive backing, ensure the surface area that you intend to adhere the tape light to is clean and dry. Simply
remove the backing strip and carefully lay the tape light in place working from one end to the other ensuring there are no raised sections.
3. Using a lint-free cloth gently press between the LEDs on the tape to remove any air bubbles and activate the adhesive, make sure you do
not press on the LEDs themselves as this could damage the joint.
6505 Gayhart St., Commerce, CA 90040
www.NoraLighting.com
Page 1 of 2
Caution:
• Always turn off power prior to installation or replacement.
• Tape Light contacts are very fragile, handle with care.
• Do not turn on Tape Light while on the spool, may cause the tape light to overheat and melt or ignite.
• Do not press directly on the LEDs themselves, as it may cause damage.
• Do not use the product in a potentially combustive environments.
• Do not cover this product as the covering may cause the tape light to overheat and melt or ignite.
• Do not operate with the tape light tightly coiled.
• Do not route the cord or tape light through walls, doors, windows or any like part of the building structure.
• Do not use if there is any damage to the light or cord insulation. Inspect periodically.
• Do not submerge the tape light in liquids, or install the product closer than 9.8' (3 meters) from a swimming pool surface.
• Secure the tape light using only the 3M™ tape, hangers, clips, or NATHR-680 Aluminum Channel (sold separately). Do not secure this
product or its cord with staples, nails, or like means that may damage the insulation or permanently attach to the building structure.
wiring Instructions to Controller:
1. Controller (sold separately) has male plug and the RGB LED Tape Light has the female connector. Plug male connector into female
connector together.
Polarity:
Tape Light must always be connected facing upward and red arrow on connectors must always face up. (Fig. 1)
Separable every 12":
1. The LED tape light may be separated every 12". Every 12" section is shrink wrapped around the connection point. Cut the silicone to
reveal the connection point. (Fig. 3)
2. Two separated tape light may be connected, but must be shrink wrapped (Page 2) to maintain ETL Listing.
Cutting Instructions - See back side for joining instructions:
1. The LED tape light may be cut every 6" or 6 LEDs. Every 6" section is separated by cut line. (Fig. 2)
2. Carefully cut the tape light along the line, be careful not to press on the LEDs as this could damage the joint.
3. When cutting the end of the tape light, shrink wrap the open cut with NATL-400.
Fig. 1
Fig. 2
Fig. 3
May be cut
every 6" or 6
LEDs at cut line
