Nonin CO-Pilot H500, Руководство оператора

Страница: 33 / 68

27
System Operation
Charging the System
Display and signal processor must both be charged to use system.
1. Charge the display and signal processor using the provided Nonin
chargers.
2. Insert charger into respective display and signal processor charging
ports.
During charging the system may reach temperatures of up to 45 degrees
Celsius, which is safe for contact with healthy adult skin for up to 10 minutes.
Battery
For more information, see the “Internal Power” section in "Specifications"
section on page 56.
WARNING: Do not use the signal processor or display while charging.
Charging is an operator function. To ensure patient safety, the system is
not be in contact with the patient during charging.
CAUTION: Charging signal processor at temperatures below 0 degrees
°C (32 degrees °F) will decrease battery life. Do not charge signal
processor at temperatures below 0 °C (32 °F).
SP-BLE Battery Indication Battery Level
1 blinking green light Critical to Low (0-19%)
1 green light lit, 1 blinking green light Medium (20-59%)
2 green lights lit, 1 blinking green light High (60-99%)
3 green lights are lit Full (100%)
CAUTIONS:
• Follow local, state and national governing ordinances and
recycling instructions regarding disposal or recycling of the device
and device components, including batteries.
• Batteries are a fire hazard if damaged. Do not damage,
mishandle, disassemble, service, or replace with non-specified
components.
• Do not charge Li-Ion batteries at a temperature of 0 °C (32 °F) or
less as this may result in significantly reduced battery life.
!
!