Wrong Operations
Keep your arms forward
Keep your hands together
With your eyes to
the front
标定高度方法
Height Calibration Method
1.
保持设备正常连接状态
,
将您的
VR
设备放在距离定位基站正面
2
米以上的水平地面，并确
保二者之间没有遮挡；
2.
轻按头盔定位器上的配对按键完成标定高度。
1. Keep the device normally connected, and place your VR device on a horizontal ground more
than 2 meters from the front side of the positioning base station, and ensure no barrier between
them;
2. Slightly press the Pairing Key on the headset marker to complete the height calibration.
定位问题处理
1.
同一定位范围内，无多套
NOLO
交互设备同时使用，如果必须开启多套
NOLO
设备，请
按照下图摆设
NOLO
的定位基站，避免多个基站互相干扰。
2.
同一环境下
,
无其他红外激光设备干扰如
HTC VIVE
、主动式红外摄像头等
,
无其他超声波
发射设备干扰。如有以上设备请关闭干扰设备再使用，或更换使用环境。
3.
尽量避免环境内有镜面等反射平面的存在。如果在类似环境发现设备定位抖动情况，需更
换环境使用。
4.
使用过程中切勿背对基站或遮挡手柄、头盔定位器，以上情况会导致定位丢失，如遇以上
情况请正对基站标定正方向。
5.
如遇无线干扰，导致设备定位卡顿，需重新配对处理，请参考配对说明。
Positioning Problem Processing
1. Within the same range, please ensure only one set of NOLO interactive devices is running; If
several sets of NOLO devices have to be run at the same time, please refer to the following picture
to place the positioning base station of NOLO to avoid the mutual interference between the base
stations.
2. Within the same environment, please ensure no interference of other infrared laser equipment,
such as HTC VIVE, active infrared camera and ultrasonic transmission equipment. If any of the
equipment mentioned above is running, please turn off the interference equipment or change the
environment.
3. Try to avoid the presence of the reflection plane, like mirror, in the environment. If vibration is
found in the positioning device, please change the environment.
4. In the process of use, please do not turn your back to the base station or cover the controllers,
the headset marker, otherwise, the positioning loss may occur. If the above situation occurs, please
face the front side of the base station to calibrate the positive direction.