AUDIO TONE adjustment applies to the selected search mode only. The change does not
affect the other modes.
VIBRATION
This feature provides feedback to the user by producing a vibration effect when a target is
detected. It can be used independently or together with the warning tone. When warning
tone is disabled all feedbacks are provided to the user as vibration only during target
detection.
Vibration setting is adjusted within the range of 00-05. When it is switched to 0, vibration
feature is completely disabled. If the vibration is at 01 level, the device provides long
vibration signals and at 05 it provides short vibration signals. The magnitude of the
vibration effect can vary according to the depth of the target and the swinging speed. This
setting is common in all search modes; change made in any mode also applies to the other
modes.
Vibration is not felt in the All Metal mode with weak signals; it will be felt as the signal gets
stronger. In other words, vibration does not start at the depth that warning tones are heard
but at a lesser depth. Therefore, if you perform search only with vibration and warning
tones of the device are off, you can miss weaker and deeper signals.
Vibration speed is constant in the pinpoint mode and cannot be adjusted. Vibration is off
at 0 position. 01-05 values provide the same level of vibration in the pinpoint mode. When
vibration is used in the pinpoint mode, vibration speed increases as the target is
approached and it reaches the maximum level over the center of the target.
BACKLIGHT
It enables you to adjust the keypad and display backlight level according to your personal
preferences. It ranges between 0-5 and C1-C5. At 0 level, the keypad and display backlight
are off. When set between 1-5, it lights up only for a short period of time when a target is
detected or while navigating the menu and then it goes off. At C1-C5 levels, it will light up
constantly. As the constant operation of the backlight will affect power consumption, it is
not recommended.
The backlight setting is restored to the final saved setting when the device is turned off
and on again. This setting is common in all modes; change made in any mode also applies
to the other modes.
Factory Default /Save (FD/Save)
With the FD/Save feature of the
RACER 2
, you can save your settings or restore factory
defaults. Save function saves all settings except for the ground balance and tracking. The
device starts in the last mode where the save function was performed. For example, you
changed the settings of both the All Metal mode and the Deep Mode and you saved the
settings while in the Deep mode. Your device will start in the Deep mode upon next start up.
To save your settings, select FD/Save on screen. SA will be displayed. To confirm, pull the
trigger once and release. SA will stay on screen for a short period of time and it will disappear
when saving is completed.
Page 11
Menu
