NOKO NOKOFORZA 2022, Руководство пользователя

Страница: 20 / 31

38 39
Before each ride, please check the correct tension of the belt or the chain ;
both need to be properly placed in location for the correct use.
Verify that all bolts, fasteners of front and rear wheels, and kickstand (if
any) are steady. Check that both pedals are properly tightened in the crank
arms; if needed remove and reinstall the pedals, following the instructions
in Chapter 6.
Make sure that the battery of your NOKO is completely charged, especially
when travelling long distance. Instructions on how to properly charge the
battery of your NOKO are included in Chapter 9.
8.2 WHEEL REMOVAL AND INSTALLATION.
Follow the instruction or view our video guides on nokobike.com, how to re-
move and install independently the wheel of your NOKO, in case of necessity.
It is recommended to visit a in a specialized service center, to ensure the
correct position of the wheel, chain or belt.
What do you need? 6 mm hexagonal wrench for the front wheel; 8 mm
hexagonal wrench for the rear wheel.
For the NOKO e-bikes, to disassemble the front wheel, the first step is to
loosen the thru-axle using the hexagonal wrench of 6 mm. Proceed by pull-
ing out the pin manually, and remove the wheel.
BEFORE EVERY RIDE
To install the wheel, guide the wheel in position by sliding the pin back
and manually tighten the thru-axle. Conclude by tightening with the 6 mm
hexagonal wrench.
For the models NOKOFORZA and NOKOTEMPO , to disassemble the rear
wheel, remember to release the tension of the belt: bring down the belt
tensioner and lock it by pressing the button.
Shift the belt from the front cog and rear sprocket, to facilitate the process.
Proceed by loosen the washers from both side of the hub axle, without
completely removing them. At this point, guide the wheel out of the drop-
outs. To install the wheel, assure that the belt is positioned over the bodice,
then proceed guiding the wheel back in the dropouts. At this point, place
the belt first in the front cog and then the in the rear sprocket, making sure
that the belt is positioned above the belt tensioner. Proceed by tighten the
washer on both side of the hub axle, manually at first, then with the 8 mm
hexagonal wrench. Conclude, by removing the lock and bring the belt in
tension again.
The belt tensioner is equipped with a spring tensioner system.
Pay close attention while removing the block. It is advisable to
accompany the belt tensioner manually, to avoid colliding with
the frame and/or getting injured.
For NOKOVULCANO , to disassemble the rear wheel, remember to release
the tension of the chain: by using the set paddles shift gear and place the
chain on the smaller sprocket. Bring down the lower cog of the derailleur
and lock it by pressing the button. Proceed by loosen the washers from
both side of the hub axle, without completely removing them.
BEFORE EVERY RIDE