NOKO NOKOFORZA 2022, Руководство пользователя

Страница: 16 / 31

30 31
The handlebar is already adjusted in ordinary height and perpendicularity.
If modification are needed, we recommend to contact a specialised ser -
vice center, otherwise act on the four front bolts.
In case of NOKOVULCANO, once you removed the e-bike from the
box, gently move the handlebar first upwards away from the top tube
and gently turn it forward. Proceed adjusting the handlebar following
the instructions above.
INSTALL THE SEATPOST.
What tools do you need? 4 mm and 6 mm allen hexagonal wrenches.
• To install the seatpost start by loosen the bolt found on the seatpost collar
using a 4 mm allen wrench, apply a small quantity of bike grease on the bot -
tom of seatpost. It should easily slide into the frame. Make sure to slide the
seatpost past the minimum insert line; align your saddle to the desired height.
• Tighten the seatpost hex bolt at the collar with an allen wrench, just
enough to make little adjustments, if needed. The saddle should not be
moving; fasten bolt of the seatpost collar.
• Adjust the saddle fore/aft position and inclination according to the per-
sonal needs, using a 6 mm allen wrench.
ARRIVAL OF YOUR NOKO
INSTALL / REMOVE PEDALS.
What tools do you need? 15 mm wrench.
Before installing, remember pedals are not interchangeable; right pedal is
marked with the letter “R” and left pedal is marked with the letter “L”.
The right and the left pedal are installed and removed in opposite ways.
• To install the right pedal, first grease the thread and fit the pedal in, then
start tightening with your hands. Tighten it with the 15 mm wrench, turning
clockwise towards the front wheel.
• To install the left pedal, first grease the thread and fit the pedal in, then
start tightening with your hands. Tighten it with the 15 mm wrench, turning
counterclockwise towards the front wheel.
• To remove the right pedal, use the 15 mm wrench and turn counterclock-
wise towards the rear wheel; once loosen use your hands to remove it.
To remove the left pedal, use the 15 mm wrench and turn clockwise to-
wards the rear wheel; once loosen use your hands to remove it.
ARRIVAL OF YOUR NOKO