Connect the fiber optic cable with SC/APC adapter to the SC/APC connector on the bottom of
the ONT.
Note:
Fiber cable preparation varies depending on the type and size of the inside or
outside plant fiber cable being spliced to the SC/APC fiber optic pigtail cable.
6
Connect the power cable to the power connector.
7
Power up the ONT unit by using the power switch.
8
If used, enable the Wi-Fi service.
a. Locate the WLAN button on the ONT; see
Figure 6-1, “XS-2426G-B ONT connections”
for location of the WLAN button.
b. Press the WLAN button to change the status of the Wi-Fi service.
9
Verify the ONT LEDs, voltage status, and optical signal levels; see the
Nokia ONT Hardware
and Cabling Installation Guide
.
10
Activate and test the services; see the
Nokia ONT Hardware and Cabling Installation Guide
.
11
If necessary, reset the ONT.
a. Locate the Reset button on a XS-2426G-B indoor ONT as shown in
2426G-B ONT connections” (p. 65)
b. Insert the end of a straightened paper clip or other narrow object into the hole in the Reset
button to reset the ONT.
E
ND OF STEPS
6.8
Wall mount an XS-2426G-B indoor ONT
This chapter provides the steps to mount an XS-2426G-B indoor ONT on a wall using a wall mount
bracket (3FE 49471 AA). The XS-2426G-B indoor ONT is shipped without the wall mount bracket.
The wall mount bracket (3FE 49471 AA) must be ordered separately.
Install a XS-2426G-B indoor ONT
Wall mount an XS-2426G-B indoor ONT
Nokia ONT
Review
Review
December 2021
Issue 1
67
© 2021 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3FE-49546-AAAA-TCZZA