2
Configure the following parameters:
Table 8-19
GRE Tunnel parameters
Field
Description
Tunnel Name
Select
Create new GRE Tunnel
or select an existing tunnel from the list.
The tunnel name is automatically assigned by the system.
Up to 4 GRE tunnels are supported.
WAN Interface
Select a WAN interface from the list.
GRE tunnels can only be created on HSI-enabled WAN interfaces.
Primary Remote End
Secondary Remote End (optional)
Enter an IP address or FQDN that is unique in the system.
If the primary remote endpoint is down or unreachable, the secondary remote endpoint
becomes active, if configured.
The secondary remote endpoint remains active until it becomes unreachable, in which
case the primary remote endpoint becomes active again. Revertive mode is not
supported.
If both endpoints are unreachable, the GRE tunnel is declared down.
Connected Remote End
This field displays the current data traffic path for the GRE tunnel.
Connectivity check
This feature is automatically selected by the system.
Traffic timeout to start pings
Enter the traffic timeout in seconds (2 to 1024).
No. of retries before unreachable
Enter the number of retries before the tunnel is declared down (0 to 100).
Figure 8-24
GRE Tunnel page
Configure a XS-2426G-A indoor ONT
Network configuration
Configuring GRE tunnel
Nokia ONT
Draft
Draft
Nokia – Proprietary and Confidential
Use pursuant to applicable agreements
3FE-49348-AAAA-TCZZA
December 2020
116
Issue 1