
2. In the Tuning menu, choose WCDMA
→
Rx Calibration .
3. Click Start.
4. Select Band.
5. Click Tune.
6. Setup the signal generator to correspond with the values on the,
Rx Calibration
pop-up window and
click OK.
Figure 57 Pop-up window for WCDMA2100
7. Repeat step 6. for Middle and High channels.
8. Ensure Tuning Results are within limits specified in the table below:
If values are OK, click Write to save the values.
RM-132; RM-133
RF Troubleshooting and Manual Tuning Guide
Nokia Customer Care
Issue 1
COMPANY CONFIDENTIAL
Page 7 –45
Copyright © 2006 Nokia. All rights reserved.