Noblelift RT16P, Руководство по техническому обслуживанию

Страница: 19 / 50

17
b. Power-on operation
Before operating the truck, make sure that the load is stable and will not cause poor
visibility.
Pull the emergency button (1), insert the key switch (2), and turn it clockwise to the
"ON" position, then step on the safety switch (6). Before start the truck, please press
the horn button (11) to start the horn to warn others if necessary. The truck is power on.
Note: please set the direction switch in the middle before power-on operation,
otherwise the operation sequence fault will be reported.
c. Travelling
After starting the truck by turning the inserted key to the
“
ON
”
position, firstly step the
safety pedal switch (6), then put your hand on the operating area. Put the switch on the
forward or backward direction, and there is arrow which means forward or backward on
the indicator, just touch it. Control the travelling speed by moving the accelerator pedal
(4) carefully until you reached the desired speed. The speed will be slower if you
release the accelerator pedal, control the speed to ensure safety. If you need sharp
slowdown, please stamp the brake pedal(5).
Drive carefully the truck to the destination. Watch the route conditions and adjust the
travelling speed with the accelerator button.
This truck is equipped with enough safety equipment to avoid accidents. When the
height of the fork is higher than the free lifting height, the speed of the truck will be
reduced to achieve smooth walking and safe work. When the fork lower below the free
lifting height, the lower the fork height, slower the truck.
Please keep the lifting height of the fork below 0.5 m when you need to travel over a
longer distance.
Please drive the truck to the safe storage area and lower the fork to the lowest position
after every use. Turn the key counterclockwise to the "close" position and pull out the
key.
Attention: Turn on the power supply, the system will start self inspection. If there is
something wrong with the electrical system, such as open circuit, short circuit, or button
on the active state, and you stamp the pedal switch, speed controller will not in the
neutral position, and the truck will not drive and report default, only when the electrical
system is OK, the truck will start normal work.
d. Steering
THE TRUCK IS EQUIPPED WITH AN ELECTRIC STEERING SYSTEM. TAKE CARE BY