16
When charging is finished, disconnect the plug (19) from the socket and place it in the designated pocket.
It
’s also allowed to remove the battery out and charge in dedicated area.
Table 4: LED-Status
Table 5: Charger of PTE15-C/SPTE15-C
8. REGULAR MAINTENANCE
Only qualified and trained personnel are allowed to do maintenance on this truck.
Before maintaining, remove the load from the forks and lower the forks to the lowest position.
If you need to lift the truck, follow chapter 4b by using designated lashing or jacking equipment.
Before working, put safety devices (for instance designated lift jacks, wedges or wooden blocks)
under the truck to protect against accidental lowering, movement or slipping.
Please pay attention by maintain the tiller arm. The gas pressure spring is pre-loaded by
compression, carelessness can cause injury.
Use approved and from your dealer released original spare parts.
Please consider that oil leakage of hydraulic fluid can cause failures and accidents.
It is allowed to adjust the pressure valve only from trained service technicians.
Check the items emphasized in maintenance checklist.
a. Maintenance checklist
Table 7: Maintenance checklist
Interval (Month)
1
3
6
12
Hydraulic system
1
Check the hydraulic cylinder(s), piston for damage noise and leakage
2
Check the hydraulic joints for damage and leakage
3
Inspect the hydraulic oil level, refill if necessary
4
Refill the hydraulic oil ( 12 month or 1500 working hours )
5
Check and adjust function of the pressure valve (1500kg (PTE15-C) +0/+10%)
Mechanical system
6
Inspect the forks for deformation and cracks
7
Check the chassis for deformation and cracks
8
Check if all screws are fixed
9
Check the push rods for deformation and damages
10
Check the gearbox for abnormal sound and noise
11
Inspect the wheels for deformation and damages
LED- signal
Function
Red
Charging
Green
Fully charged
Model
Specification
Input
Output
DZL482006/BZ3D51J3 48V3A (CHN)
180Vac -240Vac
～
2.0A MAX
54.6V 5.0A
