NKT Photonics A301-100-000, Руководство по эксплуатации продукта

Страница: 34 / 47

Control panel
34
Output power monitor – check the box next to “Output power monitor” to toggle
ON the display of the gain setting and monitor signal level in the status panel.
Figure 22 View settings
Bandwidth
restrictions
These two settings allows the output bandwidth to be greater than 100 nm or
less than 10 nm
Allow bandwidth higher than 100 nm – check the box to increase the bandwidth
to a maximum of 440 nm. Using bandwidths greater than 100 nm results reduces
the quality of the output spectrum.
Allow bandwidth lower than 10 nm – check the box to allow a bandwidth that is
less than 10 nm. Using bandwidths smaller than 10 nm reduces the quality of the
output spectrum.
Figure 23 Bandwidth restriction settings
Control panel
The Control panel displays the VARIA Wavelength settings adjusted with slider
controls or the individual text input fields. The standard Wavelength settings
configures the:
•
Center (wavelength) – slider control for the center wavelength of the filtered
output. The wavelength is set using either the slider control or a text input
field for direct input of the wavelength. Range : 400 to 840 nm
Check to toggle ON displaying status panel System info and/or
System info and/or Output power monitor parameters.
Check each box to change the minimum and maximum
bandwidth range