NKD Fonz, Руководство пользователя

Страница: 25 / 29

Suspension
Rear Mono Shock Absorber
Spring Preload Adjustment
1. Use an adjusting wrench to loosen the upper ‘locking’
collar
2. To adjust, use the adjusting wrench to turn the lower
‘adjusting’ collar
3. For sag measurements less than the standard setup,
decrease the preload on the spring by turning the
adjustment collar counter-clockwise on the shock. If more
than the standard setup, increase the preload on the
spring by turning the adjustment collar clockwise on the
shock.
4. Once the lower collar is adjusted to preferred setting,
fasten the locking collar against adjusting collar
⚠ WARNING
Ensure the spring adjustment nut is tight against the
spring before riding the vehicle
TIP Clean any dirt or debris from the slots of the shock adjusting collar before adjusting
Rebound Adjustment
The rebound ‘tension’ damper adjuster screw is located at bottom of the shock.
Printed on the shock, is “F” meaning faster rebound and “S” meaning Slower rebound.
Use a flathead screwdriver to adjust the rebound.
F Faster rebound and a softer ride, is better for
big impacts
S Slower rebound and a firmer ride, is better for
smaller and more frequent impacts
Note: There are 15 clicks of adjustment. The adjustor
should never be forced completely; always leave one
click of adjustment in either direction
25
Fonz NKD Owner Manual 2021-04-V3