Nivus NivuFlow 650, Инструкция по эксплуатации

Страница: 92 / 173

Instruction Manual
NivuFlow 650
page 92 NF 650 - rev. 01 / 29.06.2020
32.3 Setting parameters in h-Sensors Menu
After setting the measurement place parameters one or more level sensors need to be defined
and the according measurement ranges must be specified.
The level sensor parameters can be set in >h-Sensors< submenu.
32.3.1 h-Sensor types
Fig. 32-10 Level Sensor Selection
The field >h-Sensor types< contains a selection of level sensors.
 Ü
Open parameter >h-Sensor types< and select the type of sensor connected to the trans-
mitter.
For the very most applications it is sufficient to select one level sensor.
 Ü
In case of using more than one level sensor (e.g. i-Sensor and 2-wire level) check one box
for each sensor.
Sensor connected?
After finishing the parameter settings the missing or faulty programmed sensors are detec-
ted and the instrument issues an error message.
The number of selected sensors corresponds with the number of individual level measuring
section covering the entire measurement cross section. Only one level sensor can provide a
valid reading per measurement. The transmitter does not accept faulty and not reasonable
combinations.
A
maximum of three different level sensors can be selected.
Adjust the sensor measurement ranges underneath the channel graph.
Sensor detection
The transmitter does not recognise the type of 2-wire level sensor. Hence, the indication of
the sensor in the display is not crucial for the measurement range.
As standard the transmitter indicates the 2-wire level sensor as ultrasonic sensor from the
top.
The level sensors are shown within the channel shape previously specified when setting the
measurement place parameters: >Application< / >Measure place<.