RIDING AT NIGHT
While a Lumina lighting system will improve your view, control
and enjoyment of night riding, please remember that cycling
at night is an inherently dangerous activity. In addition to using
your lighting system properly and riding with extreme caution,
NiteRider urges you to:
• Never ride alone.
• Always let someone know where you are going.
• Wear a helmet and reflective clothing.
• Carry an auxiliary light and emergency supplies.
• Make sure the headlamp & mounting bracket is
securely fastened.
IMPORTANT INFORMATION !
LOCK THE HEADLAMP FOR TRANSIT
It is important to lock the headlamp and protect the switch
from being pressed while it is in transit. The headlamp can be
easily turned on if placed in something like a backpack, duffel
bag or suitcase. The headlamp gets hot while in operation. To
prevent potential damage from high heat or even fire, it is very
important to put the headlamp in lock mode and protect the
switch from being pressed.
NiteRider will not be held responsible for damages to person
or property resulting from a failure to follow the ‘lock’ mode
instructions.
PROTECTING YOUR INVESTMENT
Properly charge your battery to maximize its lifespan. (See the
“Battery Charging and Care” section for detailed information)
The Lumina will perform in wet weather conditions, but
submerging it in water will damage the system.
SUPPORT
If you experience difficulties during product installation
or operation, NiteRider provides free telephone support
on weekdays from 8:00 AM to 4:30 PM (Pacific Time) at
800.466.8366, ext 4.
You may also e-mail us at [email protected].
WARRANTY
NiteRider stands behind its products with the following
warranties:
•Lifetime warranty on all mechanical components
•2 years on electrical components
•180 days on rechargeable batteries
To obtain warranty service, it is preferable to have your
original sales receipt. Contact the NiteRider customer
service department at 800.466.8366, ext 4 to obtain a
Return Merchandise Authorization (RMA) number. The RMA
number must be prominently displayed on the outside of your
package. The product must be properly packaged to prevent
damage in transit. For complete warranty information, please
visit our website at www.niterider.com.
The Lumina 700 will run up to:
The Lumina 550 will run up to:
The Lumina 350 will run up to:
The Lumina Flare will run up to:
RUN TIMES
Light Level
High
Med
Low
Walk
Light Level
High
Med
Low
Walk
Light Level
High
Med
Low
Walk
Light Level
High
Med
Low
Walk
Time*
1:30
3:00
5:30
18:00
Time*
1:30
3:00
5:30
18:00
Time*
2:00
4:00
6:00
21:00
Time*
1:30
3:00
5:30
18:00
Lumens
700
350
200
40
Lumens
550
250
150
40
Lumens
350
200
125
30
Lumens
650
350
200
40
*Run times are approximations and will vary.
Lumina Series
User Guide
NiteRider Technical Lighting Systems, Inc.
8295 Aero Place, Suite 200
San Diego, CA 92123
www.niterider.com
150-23219 - Rev A
Lumina: 350, 550,
Flare, 700
LUMINA FLARE OPERATION
The Lumina Flare headlamp is shipped in lock mode. In order
to use the headlamp it must be unlocked. To unlock the
headlamp, press and hold the power button for several
seconds until the power button turns, or flashes blue. Release
the power button.
The Lumina Flare has 5 front light modes - low, medium and
high beam - daylight flash mode and walk mode. Press and
release the headlamp power button to turn the light on. Cycle
through the three brightness levels by pressing and
releasing the power button.
To access the daylight visible flash mode and walk mode,
press and hold the power button for greater than 3 seconds
or until the headlamp begins to flash.
With the headlamp in flash mode, press and release the power
button to access walk mode. From walk mode you can return
to normal mode by pressing and releasing the power button.
To turn the front light off from either normal, flash, or walk
mode, press and hold the power button until the light turns off.
The Lumina Flare has 3 rear light modes – Flash Mode, Steady
High, Steady Low. To turn the rear light on, press and release
the rear lens. Cycle through the 3 modes by pressing and
releasing. To turn off the rear light, press and hold the rear lens
for 2 seconds.
Always put the light into lock mode during transport of the
headlamp. To put the headlamp in lock mode, press and hold
the power button for several seconds until the headlamp turns
off and continue holding the power button down through flash
mode until the power button turns or flashes red. Then let go
of the Power button and test to make sure the light is in Lock
Mode by tapping the power button. The light will not turn on if
the lock mode is engaged. To Unlock the lock mode- See step
#1 of OPERATION.
1.
2.
3.
4.
5.
6.
7.
