© 2017 Adolf Nissen Elektrobau GmbH + Co. KG
ENGLISH
Mobiles LED-Pannenleitset
22
2.5.5
Care
Dirty and/ or wet LED guide light elements must be cleaned and dried before inserting them again
in the transport and charging case.
NOTE!
The transport and charging case is constructed for use in vehicles. When it is used outside it must be
protected from humidity and dirt.
2.6
Troubleshooting
When an LED guide light element with charged battery can not be synchronized the complete system
should be reset.
Proceed as follows:
·
Plug the charging cable in and make sure that the power supply is available.
·
Keep the toggle switch pressed until the status LED starts lighting (approx. 6 seconds).
·
Then let go the toggle switch. The status LED keeps lighting. Reset and restart of the guide light
elements are executed automatically. The process is finished when the status LED switches off.
NOTE!
The LED guide light elements should all be started and synchronized. If the problem still occurs after
repeated reset please contact our service.
·
Should the LED guide light elements fail to flash after removing them from the transport and
charging case repeat the charging process and check again.
·
If the elements fail to charge, check the fuse in the charging cable firstly and replaced it with
a fuse of the same type and rating, if necessary.
2.7
Technical data of the system
Operating voltage
: 10-30 Volt DC
Current consumption
: approx. 0,4A at completely discharged battery
approx. 30mA at completely charged battery
Charging time
: approx. 10 hours for completely discharged battery
Operating time
: >16 hours
Sequence stability
: >4 hours
On-time
: 100 ms
Max. light intensity
: yellow - approx. 500 cd
blue - approx. 100 cd
Light opening
: 15° horizontal/ vertikal
Impulse rate
: 60 fl/min / 1Hz
Battery type
: lithium iron phosphate (LiFe-Po4) battery
Insulation
: IP66 (LED Guide Light Elements)
Dimensions
: LED guide light elements 100x90x25
transport and charging case 260x160x125
Содержание 141060-1
Страница 2: ......
