- 8 -
140
180
220
PRESET PRESSURE
AC
MANUAL
ADAPTOR PLUG
Screw driver
BATTERY PLUG
OPERATION WITH AC ADAPTOR
Connect AC ADAPTOR PLUG to AC CONNECTOR.
Plug AC ADAPTOR in the power socket.
AC INDICATOR is lit when AC ADAPTOR is connected correctly.
OPERATION WITH RECHARGEABLE NiMH BATTERY
The battery supplied with the product is not charged and needs to be charged for
about 4 hours before use.
Turn off the power and unplug AC
ADAPTOR before inserting the battery.
Make sure " " side of MAIN POWER
SWITCH is pressed down.
Remove BATTERY COMPARTMENT COVER by
loosening and removing the screw.
Connect BATTERY PLUG to BATTERY
CONNECTOR inside the battery compartment
and insert the battery.
Put back BATTERY COMPARTMENT COVER and
close it by inserting and tightening the screw.
Connect AC ADAPTOR PLUG and plug AC
ADAPTOR in the power socket to charge the
battery.
The battery will be charged regardless whether the
device is turned on or off.
Orange light of AC INDICATOR indicates that
the battery is being charged.
The battery is fully charged after approximately 4 hours.
Unplug AC ADAPTOR when the light turns
green this indicates the battery is charged.
TIGHTEN
LOOSEN
ORANGE : charging
GREEN : charged
The color of AC INDICATOR may
fluctuate from green to orange if
DM-3000 is operated while charging
battery, this does not indicate a problem.
WARNING, PRECAUTION, and CONTRAINDICATION
CONTRAINDICATIONS
• Do not use this product along with implantable and wearable medical electrical
equipment such as pacemaker, defibrillator, or electrocardiographic monitor.
• Do not use this product in an explosive environment such as near flammable
anesthetics or inside oxygen chamber.
• Do not use cuffs or accessories other than those specified by the manufacturer.
Otherwise, correct measurement readings cannot be obtained.
• Do not apply the cuff over wounded arm, arm under an intravascular access or
therapy or an arterio-venous shunt, or arm on the side of a mastectomy or lymph
node clearance. Otherwise injury may be resulted.
• Do not make measurements repeatedly to avoid harmful injury due to interfered
blood flow from cuff inflation.
• Do not drop or strike the product. Make sure not to expose it to moisture. This
product is not water resistant.
• Do not press the display or place the monitor with display face down.
• Do not take out batteries or unplug the AC adaptor when the monitor is turned on.
Make sure to switch off the monitor before removing batteries or AC adaptor.
• Do not touch the output plug of AC adaptor during measurement.
• Do not disassemble or modify the product.
• Do not inflate the cuff when it is not wrapped around patient’s arm.
• Do not apply the cuff on the limb which the intravenous drip infusion is implemented.
• Do not take measurement of neonate in any case. Do not take measurement of
children for automatic measurement.