NINCOAIR is brand of NINCO DESARROLLOS S.L.
Ctra. de l’Hospitalet 32
08940 Cornella Barcelona Spain
CIF B-60307725 · www.nincoair.com
4
NH92013 RTF – NH92014 ARF CESSNA 400
ENGLISH
WARNINGS:
Radio control models are not toys. Serious injury to people or damage to property can result if not used in a responsible manner.
It is not recommended for children under 14 years old and should only be flown by experienced radio control pilots. It is recommended that this model only be
flown at dedicated radio control flying sites.
Read all instructions carefully prior to assembling and before flying this model. Seek advice should any information be unclear. You assume all risk and
responsibility when using this model.
SPECIFICATIONS:
Wingspan:
1400mm
Length:
1020mm
Weight:
1240gr
Battery: Li-Po 11,1v
Motor/ESC: Brushless
Radio: 2,4 Ghz, 4 Ch, 4 servos
*****The ARF version does not include transmitter and receiver.
1. TRANSMITTER OPERATION AND FLIGHT CONTROLS.
The transmitter requires 8 AA size alkaline batteries (not included). Fit them into the battery compartment at the rear of the transmitter paying careful attention in
order to observe correct polarity.
Mode 2
1. Rudder control
5. Elevator trim lever 9. Servo reverse switches
2. Throttle control
6. Aileron control
10. On/Off power switch
3. Rudder trim lever 7. Elevator control
11. Battery indicator
4. Throttle trim lever 8. Aileron trim lever
12. Power indicator
Before turning on the transmitter, make sure the throttle stick is pulled all the way back. Switch on the transmitter.
2. CHARGING THE BATTERY
Do not charge the battery more than 120 minutes. Before the first flight, the battery should be circled 3-4 times to ‘wake’ it up for its best flight performance.
Please, follow the charge instruction that follow in order to charge the flight battery:
Connect to flight
battery
Charging indicator
DC12v power source
Charge with wall adapter
Charge with car battery
