TRANSMITTER
HELICOPTER FLIGHT
Before flight:
Binding:
EVO MICRO and PHOENIX MICRO
1.- Remove the battery from the helicopter (PHOENIX, open the below cover)
2.- Connect the USB cable to the USB port of a computer (preferably,) a wall charger (not included) or the transmitter.
3.- Connect the charging plug of the cable to the battery.
4.- After 2 seconds, the USB connector LED remains solid red. When finished charging, the LED turns off.
1.- With the helicopter battery disconnected, switch ON the
.
2.- Connect the helicopter battery.
3 .- Place the helicopter on the ground with the tail pointing toward you.
transmitter
INSTALLATION AND BATTERY CHARGE
Transmitter:
Helicopter:
Dual rate. User-level:
Switch in position OFF
1.- Open the battery covers.
2.- Fit the batteries (respect polarity).
3.- Close battery covers.
Helicopter and transmitter come linked from the factory.
If the helicopter LED flashes rapidly for 5 seconds and then remains fixed, when helicopter and transmitter are ON is that
they are correctly paired. If after 5 seconds blinking slowly, it is necessary to make the binding.
1.- Transmitter in position OFF.
2.- Insert the Li-Po battery in the helicopter and switch ON. The light flashes 5 seconds. While blinking, press the left stick and turn on the
transmitter at the same time. Release. The LED blinks and changes color red-green alternately while beeps. When it stops beeping and the LED is
solid red, the binding has ended.
The user has Beginner (70%) or Advanced (100%) control depending on your piloting skills. Push the right lever to change
level. Advanced is ideal for experienced riders. Beginner choice is recommended if it is the first flight of the user, since it is
slow and progressive movements.
6
NINCOAIR is brand of NINCO DESARROLLOS S.L.
Crta. de L’Hospitalet 32
08940 Cornellà - Barcelona - Spain
CIF B-60307725 - www.nincoair.com
HANDBOOK
ENGLISH
