TRANSMITTER
HELICOPTER FLIGHT
Before flight:
There are two ways to charge the battery:
1) Connect the USB cable to the USB port of a computer (preferably) or a wall charger (not included). Connect the
charging plug into the helicopter (CHA).
2) Switch in position OFF. Open the charger cable cover. Connect the cable between the transmitter and the helicopter
(CHA). Switch ON the transmitter.
1.- With the helicopter battery disconnected,
Switch ON
the
.
2.- Connect the helicopter battery.
3 .- Place the helicopter on the ground (very important for the operation of the gyro), with the tail pointing toward you.
transmitter
Switch ON the helicopter.
INSTALLATION AND BATTERY CHARGE
Transmitter:
Helicopter:
Trim adjustments:
Switch in position OFF
1.- Open the battery covers.
2.- Fit the batteries (respect polarity).
3.- Close battery covers.
select the band in the transmitter A, B o C and the helicopter will automatically identify it.
4. Synchronizing transmitter and helicopter: Full push the left stick for a second, then pull back.
1. Push again the left stick SLOWLY to start the flight (approx. between 0,5m and 1m).
2. If the tail turns left or right, please trim it using the trim button on the transmitter. Turn it to the left or the right until the helicopter stops turning.
5
NINCOAIR is brand of NINCO DESARROLLOS S.L.
Crta. de L’Hospitalet 32
08940 Cornellà - Barcelona - Spain
CIF B-60307725 - www.nincoair.com
HANDBOOK
ENGLISH
POWER INDICATOR
UP-DOWN
POWER INDICATOR
CHARGING CABLE
(BACK)
TRI-BAND CHANNEL
TURN LEFT-RIGHT /
FORWARD-
BACKWARDS
POWER/CHARGE
SWITCH
