Verify that the APN has been changed by checking the PDP context configuration.
Type the command followed by the enter key:
AT+CGDCONT?
The modem should respond with:
+CGDCONT: 1,"IPV4V6","ims","",0,0,0,0
+CGDCONT: 2,"IPV4V6","vzwadmin","",0,0,0,0
+CGDCONT: 3,"<IPTYPE>","<APN>","",0,0,0,0
+CGDCONT: 4,"IPV4V6","vzwapp","",0,0,0,0
+CGDCONT: 5,"IPV4V6","","",0,0,0,1
+CGDCONT: 6,"IPV4V6","vzwclass6","",0,0,0,0
OK
2.4.7.5.2
LTE M1 and Non-Verizon LTE Cat 1+ Device APN Configuration
LTE M1 devices on all carriers and non-Verizon LTE Cat 1+ devices typically use PDP
context 1 for their data connections and manual APN configuration.
LTE Cat 1+ non-Verizon devices will need to have their APN manually configured.
LTE M1 devices can either have their APN manually entered or be configured to
request the APN from the cellular network each time the modem connects by leaving
the APN blank.
Note:
Some carrier SIMs may load APNs into the PDP contexts upon boot. These
APNs may not be the correct APN for the customer's data plan and will need to be
configured on each bootup.
To manually set the APN follow these steps. Issue the following command followed by
the Enter key to change the APN in the first PDP context:
AT+CGDCONT=1,"<IPTYPE>","<APN>"
Where
<IPTYPE>
is IP (for IPV4), IPV4V6, or IPV6 and
<APN>
is the APN provided
by your cellular data plan vendor. Most devices should use IPV4V6 for their data plan,
but this will depend on what IP type the cellular data plan is configured to support.
Verify that the APN has been changed by checking the PDP context configuration.
Type the command followed by the enter key:
AT+CGDCONT?
The modem should respond with:
+CGDCONT: 1,"<IPTYPE>","<APN>","",0,0,0,0
OK
PN 1002634 REV 1
© NimbeLink Corp. 2021. All rights reserved.
18
